View source

From Thermal-FluidsPedia

for Flow patterns of liquid-vapor (Gas) two-phase flow

You do not have permission to edit this page, for the following reason:

The action you have requested is limited to users in the group: Users.

You can view and copy the source of this page:

Two-phase flow refers to the interactive flow of two distinct phases – each phase representing a mass or volume of matter – with common interfaces in a channel. Two-phase flow can occur in a single-component or multicomponent system. Possible phase combinations include: (1) solid-liquid, where solid particles are mostly dispersed in the liquid; (2) solid-gas, where the solid particles are carried by a stream of gas; (3) liquid-vapor (gas), where the volume fraction of one phase relative to the other results in different flow regimes; and (4) a combination of the above. While each of these modes represents a significant area of two-phase flow, liquid-vapor (gas) flow is by far the most common in various industries and thus has been investigated in greater depth. Therefore, the major emphasis of this chapter is on liquid-vapor (gas) flow.

Each regime in liquid-vapor (gas) two-phase flow has a characteristic flow behavior that can substantially affect both pressure drop and heat transfer. In the case of a single-component two-phase flow, such as forced convective condensation or evaporation, continuous mass transfer occurs between the vapor and liquid phases. Examples of liquid-gas flow processes include distillation, fractionation, flashing, spray-drying, stripping, and absorption. There are also two-component liquid-gas systems where the gas is noncondensable; these include air/water flow in aeration, deaeration, and humidification or dehumidification processes. A biomedical engineering example is the development of artificial lungs where absorption of oxygen or desorption of CO<sub>2</sub> from blood is required.

Among the kinds of two-phase flows summarized in the preceding section, liquid-vapor (gas) flow is the most complex because the interfaces are deformable and the vapor or gas phase is more common. Furthermore, the interfacial configurations in two-phase flow are also very complicated due to heat and mass transfer and can vary over a wide range.  The interfacial distribution in the liquid-vapor (gas) flow can be classified into a number of categories known as flow patterns or flow regimes. Flow regimes and flow regime transitions for vertical and horizontal tubes will be discussed. The flow patterns that will be presented in this section apply to two-phase flow in straight tubes only and are not applicable for two-phase flow in bends or coils. In addition, the flow patterns that will be addressed in this section are for cocurrent flow only and are not valid for countercurrent flow.  However, one can easily obtain useful two-phase flow information in open literature concerning various configurations in geometry and/or countercurrent flow.  

*[[Concepts and Notations for Two-Phase Flow|Concepts and notations]]
*[[Two-Phase Flow Patterns in Vertical Tubes]]
*[[Two-Phase Flow Patterns in Horizontal Tubes]] 

==References==
Faghri, A., and Zhang, Y., 2006, ''Transport Phenomena in Multiphase Systems'', Elsevier, Burlington, MA

Faghri, A., Zhang, Y., and Howell, J. R., 2010, ''Advanced  Heat and Mass Transfer'', Global Digital Press, Columbia, MO.

==Further Reading==

==External Links==

Return to Flow patterns of liquid-vapor (Gas) two-phase flow.

Retrieved from "http://thermalfluidscentral.org/encyclopedia/index.php/Flow_patterns_of_liquid-vapor_(Gas)_two-phase_flow"

View source

From Thermal-FluidsPedia

Views

Personal tools

Navigation

Search